Knowledge

Reasons for Frequent Wire Breakage In Wire Drawing Production

Frequent wire disconnections occur during the wire drawing process, which greatly affects the production progress. Let's take a look at the main reasons today. 1. The sizing area of the wire drawing d

Read More

What Is the Difference Between Bare Copper Wire, Tinned Copper Wire And CCA W...

Bare copper wire, tinned copper wire, and CCA wire are often used in the production of security cables. They can be used for braiding coaxial cables and shielding nets for shielded sheathed wires. Bar

Read More

How To Avoid Oxidation of Copper Wire When Operating The Copper Wire Drawing ...

1. The annealing machine of Copper Wire Drawing Machine with Annealing is divided into three parts: preheating section, annealing section and cooling section.Since the length of the preheating section

Read More

Common problems and solutions for Wire Bunching Machine

Wire Bunching Machine is a common mechanical device used to twist multiple cables or wires together. However, there are also some common faults that can occur with Wire Bunching Machines due to long-t

Read More

Use and Maintenance of Copper Wire Drawing Lubricant

Whether it is bare copper wire, enameled wire, tinned wire, etc., the characteristics of wire drawing emulsion itself and its correct use, maintenance and management have a direct impact on its produc

Read More

What Should be Paid Attention to Before Operating the Intermediate Wire Drawi...

1. Check whether the various oil materials are correct, whether the oil materials in the oil material cylinder meet the requirements, whether all parts of the Intermediate Wire Drawing Machine are cle

Read More

Reasons Why The Wire Diameter Is Unstable When Drawing with Polycrystalline Dies

Polycrystalline die has the advantages of good wear resistance, long service life, low price, etc., and its application in wire drawing production is constantly expanding. However, the main reason why

Read More

Self-inspection and Troubleshooting Methods of Bunching Machine

1. How to do a good job in the self-inspection of the bunching machine ? In order to make the finished product have better appearance and better quality, and avoid the loss caused by human factors as

Read More