After drawing several laps, remove the lead pliers, and then start the No. 1 machine, so that there are more than half of the semi-finished wire drawing on the No. 1 machine's wire drawing pan, and then introduce the aluminum thread end to the No. 2 machine through the hanging wheel and the threading wheel.
Carry out the second die shrinking and threading as required, and inching drawing, so as to circulate it so that the drawn wire will be drawn to the take-up wheel after passing through multiple dies, start the take-up machine, and start drawing Process.
Turn the switch knob to the linkage start main unit switch knob and wire take-up button, adjust the variable-frequency potentiometer speed control knob of each machine, and adjust the knob of the take-up torque motor controller at the same time, so that the motor speeds up at the same time, so that it can run normally. Use speed regulation to achieve the best matching effect.
