(1) There is a movable water pipe joint above the capstan, which is spray type and can move left and right without affecting the threading operation. The first and twenty-fourth eye molds are independently piped for lubrication.
(2) The lubricating fluid is introduced from the left side of the Fine Wire Drawing Machine and controlled by a ball valve, which is convenient for threading operation. When multiple machines are used together, they should be equipped with a centralized supply cooling lubricating fluid. It is recommended to use a stepped overflow cooling oil pool to facilitate cooling and deposit debris.
The capacity of the oil pool used is calculated according to the formula: 40 liters/minute × 20 × the number of Fine Wire Drawing Machines. If the capacity is less than this number, a forced cooling device must be used, and the cooling temperature must be controlled within the range of 40°C to 50°C.
* It is recommended to use "Dulwich" 9800 lubricating fluid for lubricating oil. When diluting the lubricating fluid, deionized water or demineralized water should be used as much as possible for deployment to prolong the service life of the lubricating fluid. The proportioning concentration is 2-3%.
（3）Lubricating oil concentration ratio and maintenance
The drawing oil concentration of this Fine Wire Drawing Machine is about 2-4%.
（4）The wire drawing oil pool is cleaned every 3 months on average, and the use of the wire drawing oil is observed every half a year, and then it is determined whether to replace part or all of it. It must be cleaned thoroughly after one year of use.
For more information,please click:https://www.brwiremachine.com/info/
